DTG Kiosk Specifications download pdf (Page 13)

4. Printer Set Up

Please Note: Keep all packaging, holding fixtures and instructions for the DTG Kiosk™ as you

will need them if you have to transport your system anywhere or to return it for repair. There

is a section in the back of this manual on transporting your printer. Please ensure you read

and follow these instructions.

Please read the following directions through before unpacking your DTG Kiosk™:

• Prepare a work area with a solid work table that will not vibrate when using the DTG

Kiosk™. Allow extra room for your computer, replacement inks and space to work. See diagram

below for dimensions of the unit and minimum workspace area required.

D: 1300mm

Loading Side

Ejecting Side

W: 700mm

H: 400mm

• Carefully remove the printer from the box, taking hold of it by the sides of the blue

metal housing. Do NOT lift the printer by the Printing Bed.

• Place the printer on the work table which should be leveled first. The unit must be kept

away from direct sunlight, dusty areas, excessively high humidity, strong magnetic forces and

direct airflow which can dry out and clog the printing heads.

• Protect any carpet or floor covering with mats or old carpet as there is a risk of spilling

wet ink when you refill the bulk system ink bottles.

• Place the DTG Kiosk™ as close as possible to the heat source that you are using to cure

the ink. If you have more than one DTG Kiosk™, place them around the heat source or as close

as possible to it.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 61 62

No comments

DTG Kiosk Specifications Page 13